Description of medical gloves process

- Apr 09, 2019-

The rubber is first sliced by the rubber refining machine and then sent to the sol cylinder to mix with the gasoline sol.After emulsifying and modulating, the sol is pumped to the tundish.The gasoline-soluble rubber solution is fed from the top of the distillation column and heated by steam. The light component gasoline is heated into the gas phase, and the gasoline gas is mixed and cooled by cold water in the oil-gas cooler.Oil and water mixture to the oil and water separator, oil and water stratification.The upper gasoline is recycled, and the lower water is sent to the cooling tower by the water pump.The latex in the distillation tower kettle is sent to the emulsion mixing tank under its own pressure to be stirred and mixed, and then to the centrifuge to separate the raw latex of gloves, and then to be used after color mixing and filtration.

The glove model was cleaned with acid and alkali and then washed with water. The cleaned model was immersed in hot water and heated until it was soaked with coagulant and dried before being soaked with glue.After rubber dipping, send to oven for preliminary drying, add fiber inner cover, then send hot water to oven for vulcanization, drying and forming.After demolding, the gloves are checked for air inflation, shaped at low temperature, dried at medium temperature, washed, dehydrated and dried, and then packaged and sent to the finished product warehouse.

医用手套12