The main raw material of condom made by Latex Condom Manufacture Dipping Machine For Adult Products is natural latex commonly, namely the white SAP that collects from rubber tree to resemble milk, the minute grain that contains rubber.Combining mainly refers to the process of mixing the raw material liquid used in the production of condoms.A variety of raw materials are added to natural latex to increase its elasticity and prevent aging.The reaction is then carried out in a temperature-controlled container to form the condom solution.Of course, in the chemical process, but also need to be constantly monitoring, sampling inspection, to ensure the quality of raw material liquid.Once the solution is ready, the condom formation process can begin.The hard glass mould is put into the qualified material liquid, and then the material liquid is slowly stretched to spread evenly on the surface of the mould.After the raw material liquid on the mold is dried, soak again to fill the gap.This creates a thin, uniform rubber sheath on the surface of the mold, with the edges slightly rolled up to form the shape of a condom.Depending on the shape of the mold, other types of condoms, such as threaded condoms or bump condoms, can be produced using a mold with a surface texture or bump.
The clean mould is slowly immersed in the constant temperature latex liquid, then pulled up slowly, and rotated slowly in the clean air, so that the latex can evenly cover the surface of the mould. After drying, repeat the steps of immersion and rotary drying mentioned above several times, so as to fill the "hole zone" which was not covered by latex after the last drying and eliminate the hole of condom.
The forming process is very important for the final quality of the sleeve, so there are strict requirements and control for the cleanliness of the die, the speed of the die and the temperature of the latex.
When the thickness of the rubber film on the mould reaches the requirement, the rubber film on the top edge will be rolled up, so the small rubber circle we are familiar with appears.
1. Adopt advanced three times impregnation technology, advanced process layout and diversified process production adjustment;